Owner manual

TA660 User's Manual Catalyst Enterprises, Inc

required by the selected commands are enabled. For

example, if you are using Master commands only, the

Target options are grayed out.

Looping To run an exerciser program in a loop, set Loop Master or

Loop Target or both as applicable. To loop a fixed number

of times, set the Loop Counter to On and enter the number

of loops to execute. Setting the loop counter to Off will

cause the program to loop indefinitely.

On Target Disconnect Options

Use Same Transaction Completes from the disconnect

point on, regardless of the

number of times the target

issues a disconnect. The TA660

will take it from where the

target disconnect was issued and

try to complete the transaction

from that point on.

Use Next Transaction The TA660 will bypass all of

the transactions in the current

command and will jump to the

transaction for the next

command.

On Target Retry Options

Infinite Retry The TA660 will retry the

current command until the

target transfers data.

Advance to Next The TA660 will bypass the

current command and go to the

next transaction for the next

command.

Master Abort on No DEVSEL# Options

Disabled The FRAME# will stay asserted

indefinitely and the TA660 will

not issue a Master ABORT.

Enabled The TA660 will issue a Master

ABORT on the 5

clock if no

DEVSEL# is asserted.

Master Assert FRAME#

Regardless of Grant Once the TA660 is set to

become a master, it asserts the

frame and starts the transaction

regardless of the status of the

GNT#.