Owner manual

TA660 User's Manual Catalyst Enterprises, Inc
70
Virtual Address Trigger
Make sure that the TA660 is operating in the Advanced Mode as shown on the Main
Menu bar below.
1. Click the Blue button on the Main Menu bar to open the Custom
Project dialog box shown in Figure 65.
For a Virtual Address Trigger project you must program/define:
• Virtual Address Data Capture conditions.
• A set of Event Patterns
• An Exerciser Program, if in State Analyzer & Exerciser
configuration.
Figure 65 Virtual Address Trigger Dialog Box
2. Set the Virtual Address Data Capture and Trigger Selection options.
3. Click on the Exerciser Program Tab and set the exerciser options as
described in Setting Exerciser Options on page 58.
4. Click on the Event Patterns dialog box and define up to 8 Event
Patterns as described in Defining Event Patterns on page 61
5. When complete click Run.
Note: Please note that there are several clocks, 6 to 8, between the time the
virtual address occurs until the EXT TRIG signal occurs.
Without Exerciser If you do not require exerciser generated bus traffic then
you may perform this action by switching to the Analyzer
Only configuration.