Owner manual

TA660 User's Manual Catalyst Enterprises, Inc
83
Setting Trace Options
Selecting Parameters Select the parameters to be measured from the Analyze List
Of shown in Figure 75. Move the selected parameter to the
right window for software to perform interrogation on that
parameter during post processing by clicking the =>> button
next to the Of edit box. Parameters may be defined as
minimum, average, maximum or count and or percent
depending on which unit applies. Parameters may also be
defined, if applicable, by address type.
Optimum Number of Samples Set the amount of data to be captured in the
memory for post processing for each interval. The larger the
number of samples the more time is required for
downloading and processing, Therefore you should select
an optimum number of samples to be captured to memory
such as 1000. This takes about one second to process. If
your application requires more data then a larger number
should be entered.
Update Interval If a small number of data samples is expected to be
captured, say 1000, and the application does not require
repeated measurement, you may want to sample data once
every 5 or 10 seconds by changing the Update Interval to 5
or 10 seconds as required. . The larger of the two number of
data samples or faster update rate will be the dominating
setup for data capture time.
View List Select the items you want to view on the display by
highlighting and clicking the items in the View List.
Display as Text The report in text as well as graphics may be displayed on
the screen during run time by checking the Report box.
Save Measurements All measurements may also be saved and reviewed later,
select SAVE and specify the output file name. The results
may be viewed under view.