Data Sheet

USBProtocolSuiteUserManual 131
SettingUptheAnalyzer‐USBConnection TeledyneLeCroyCorporation
3.1.4 Launching the USB Protocol Suite
Tostarttheapplication,launchtheprogramfromtheStartmenu:
Start>Programs>LeCroy>....ProtocolSuite>....ProtocolSuite
Note:Theinstalleraddsaservicewhichhelpskeepyoursoftwareup‐to‐date.Ifyoureceiveamessage
fromyouranti‐virussoftware,pleasedooneofthefollowing:Disableyourantivirussoftware
untiltheUSBProtocolSuitehascompletedinstalling,orchoosenottousetheAutomatic
Updatefeaturewhenyouarepresentedwiththisoptionduringtheinstallation.
3.2 Setting Up the Analyzer - USB Connection
TosetupanAnalyzerusingaUSBconnection:
1. ConnecttheACpowercordtotherearoftheAnalyzerandtoa100‐voltto240‐volt,
50‐Hzto60‐Hz,200‐Wpoweroutlet.
Note:TheAnalyzeriscapableofsupportingsupplyvoltagesbetween100voltsand240volts,50Hzor
60Hz,thussupportingallsupplyvoltagesaroundtheworld.
2. ConnecttheUSBporttoaUSBportonthehostmachineusingtheLONG(6‐foot/2‐
meter)USB2.0cableor1‐meter3.1cable.
3. InserttheInstallationDVD.
4. Turnonthepowerswitch.
Note:Atpower‐on,theAnalyzerinitializesitselfinapproximatelytensecondsandperformsan
exhaustiveself‐diagnosticthatlastsaboutfiveseconds.Ifthediagnosticsfail,callTeledyne
LeCroyCustomerSupportforassistance.
5. ClickNextafteryouseetheAddNewHardwareWizardwindow.
6. FollowtheMicrosoft
®
Windows
®
on‐screenPlug‐and‐Playinstructionsforthe
automaticinstallationoftheAnalyzerasaUSBdeviceonyouranalyzinghost
machine(therequiredUSBfilesareincludedontheInstallationDVD).
7. ClickFinishwhenyouseethemessagethatsaysWindowshasfinishedinstalling
thesoftwarethatyournewhardwarerequiresandthedriverfileshavebeen
installedinyourhostmachine.
8. CheckAnalyzersetupinthe“ApplicationStartup”section(See“ApplicationStartup”
onpage146).
WARNING:DonotchangefromUSBtoEthernet,orback,withoutpowercyclingtheAnalyzer.
Note:DisconnectionofUSBorEthernetduringcaptureoruploadingoftracedataisnotsupported,
andmaycausethesoftwaretomalfunctionorcrash.