User manual

ManualsBrandsTELEDYNE LECROY ManualsLaboratory Test EquipmentProtocol analyser Mercury T2C Power Delivery USB

Introduction

The Teledyne LeCroy USB Mercury T2C™ USB 2.0 Protocol Analyzer is a verification system

for USB development and testing. It supports USB 2.0 and the Power Delivery Protocol that

runs over the Type-C(TM) connector. It is designed to record USB traffic and graphically

present the logical transactions and events. It connects to a laptop or desktop PC via USB

2.0. The Mercury T2C is powered by the USB cable, so no additional power cord is needed.

Please see the Readme file on the installation DVD for the latest information on

PC requirements and supported operating systems.

The system can monitor USB 2.0 traffic (Hi Speed, Full Speed, and Low Speed) using

compliant USB 2.0 cables, as well as Power Delivery 2.0 traffic over the USB Type-C to

Type-C cables. It will work with all existing USB 2.0 devices and hosts (using the supplied

Adapters), as well as new ones incorporating the Type-C connectors.

The total length of the cables between the Host under test and the Device under test should

be kept to < 4 feet.

USB Mercury T2C

Quick Start

Components

The Teledyne LeCroy Mercury T2C Analyzer package includes the following items:

• One Teledyne LeCroy USB Mercury T2C Analyzer

• Five USB cables (A to C, C to C, C to B, C to uB, C to A Receptacle)

• Installation DVD-ROM, including documentation

• Quick Start Guide

Please see the USB Protocol Suite User Manual on the installation DVD for

component specifications.

Summary of content (4 pages)

PAGE 1
USB Mercury T2C Quick Start 1 Introduction The Teledyne LeCroy USB Mercury T2C™ USB 2.0 Protocol Analyzer is a verification system for USB development and testing. It supports USB 2.0 and the Power Delivery Protocol that runs over the Type-C(TM) connector. It is designed to record USB traffic and graphically present the logical transactions and events. It connects to a laptop or desktop PC via USB 2.0. The Mercury T2C is powered by the USB cable, so no additional power cord is needed.
PAGE 2
3 Description The front panel has the following indicators and connectors: Connector 1 LED (Green - Good) (Red - Flip it over!) Analyzer Connector 1 (downstream) Connects to Device under test (UFP). Power LED (Green if on) Status LED (Blue if system successfully initializes) (Red while booting.
PAGE 3
5 Setting Up the Analyzer To set up the Analyzer: 1. Connect the USB port to a USB port on the PC using the LONG (3-foot/1-meter) USB 2.0 cable. Note: Use of a longer cable for this connection may cause the Mercury T2C to malfunction. 2. Plug the Analyzer Host's USB cable into the USB Type-C Connector in the rear of the Mercury T2C. At power-on, the Analyzer initializes itself in approximately ten seconds and performs an exhaustive self-diagnostic that lasts about five seconds. 3.
PAGE 4
6. 7. Click on the Tool Bar. The system starts to record the USB traffic immediately. After 16 MB of traffic are recorded, the Analyzer uploads the data and displays the packets in the trace window. To terminate recording before the snapshot automatically completes, 8. click on the Tool Bar. When the recording session is finished, the traffic is automatically uploaded from the Analyzer to the hard drive on your PC as a file named data.usb or the name you assigned as the default filename.