Manual

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005 181
SAVE/RECALL SETUP
PANEL_SETUP, PNSU
Command/Query
DESCRIPTION
The PANEL_SETUP command complements the *SAV or *RST
commands. PANEL_SETUP allows you to archive panel setups in
encoded form on external storage media.
Only setup data read by the PNSU? query can be recalled into the
oscilloscope. A panel setup error (see table on page 145) will be
generated if the setup data block contains invalid data.
N
N
O
O
T
T
E
E
:
: The communication parameters (those modified by
commands CFMT, CHDR, CHLP, CORD and WFSU) and the
enable registers associated with the status reporting system
(SRE, PRE, ESE, INE) are not saved by this command.
COMMAND SYNTAX
PaNel_SetUp <setup>
<setup> : = A setup previously read by PNSU?
QUERY SYNTAX
PaNel_SetUp?
RESPONSE SYNTAX
PaNel_SetUp <setup>
EXAMPLE (GPIB) The following instruction saves the oscilloscope’s current panel setup
in the file PANEL.SET:
FILE$ = “PANEL.SET”: CMD$=“PNSU?”:
CALL IBWRT(SCOPE%,CMD$): CALL IBRDF(SCOPE%,FILE$)
Whereas the following recalls the front panel setup, stored
previously in the file PANEL.SET, into the oscilloscope:
CALL IBWRTF(SCOPE%,FILE$)
RELATED COMMANDS
*RCL, *SAV