Manual

P ART T WO : COMMANDS
184 ISSUED: February 2005 WM-RCM-E Rev D
CURSOR
PARAMETER_CUSTOM, PACU
Command/Query
DESCRIPTION
The PARAMETER_CUSTOM command controls the parameters
that have customizable qualifiers and can also be used to assign any
parameter for histogramming.
NOTE: When PAVA? is used to query a Custom parameter,
the prefix is returned for consistency. However, the source for
the measurement is the one configured using the PACU
command.
TIP: Use PAVA? to read the measured value of a parameter
that was set up with PACU . To determine the correct form of a
PACU command in your scope model it is useful to set up the
scope manually to the configuration that you want, and then
send a PACU query. The response from the scope can be
copied straight into your program for use as a query.
COMMAND SYNTAX
Parameter_Custom
<column>,<parameter>,<qualifier>[,<qualifier>,...]
<column> : = 1 to 8
<parameter> : = {a parameter from the table below or any
parameter listed in the PAVA? command}
<qualifier> : = Measurement qualifier(s) specific to each <param>.
See below.
C USTOMIZABLE P ARAMETERS ON ALL MODELS
<param> Definition <qualifier> list
AMPL Amplitude
AREA Area <source>
BASE Base
CYCL Cycles on screen
DLY Delay
DDLY Delta delay <source2>