Manual
Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
85
S
HORT
F
ORM
L
ONG
F
ORM
S
UBSYSTEM
(
CATEGORY
)
W
HAT THE
C
OMMAND OR
Q
UERY
D
OES
PACL PARAMETER_CLR
CURSOR Clears all current parameters in Custom, Pass/Fail.
PACU PARAMETER_CUSTOM
CURSOR Controls parameters with customizable qualifiers.
PADL PARAMETER_DELETE
CURSOR Deletes a specified parameter in Custom, Pass/Fail.
PAST? PARAMETER_STATISTICS?
CURSOR Returns parameter statistics results.
PAVA? PARAMETER_VALUE?
CURSOR Returns current parameter, mask test values.
PF PASS_FAIL
CURSOR Sets up pass fail system.
PFDO PASS_FAIL_DO
CURSOR Defines outcome and actions for Pass/Fail
PERS PERSIST
DISPLAY Enables or disables the persistence display mode.
PECL PERSIST_COLOR
DISPLAY
Controls color rendering method of persistence
traces.
PECS PER_CURSOR_SET
CURSOR Positions one of the six independent cursors.
PELT PERSIST_LAST
DISPLAY Shows the last trace drawn in a persistence data map.
PESA PERSIST_SAT
DISPLAY Sets the color saturation level in persistence.
PESU PERSIST_SETUP
DISPLAY Selects display persistence duration.
*PRE *PRE
STATUS Sets the PaRallel poll Enable register (PRE).
*RCL *RCL
SAVE/RECALL Recalls one of five non-volatile panel setups.
RCPN RECALL_PANEL
SAVE/RECALL Recalls a front panel setup from mass storage.
RCLK REFERENCE_CLOCK
SAVE/RECALL Toggles between internal clock and external clock.
*RST *RST
SAVE/RECALL Initiates a device reset.
*SAV *SAV
SAVE/RECALL Stores current state in non-volatile internal memory.
SCLK SAMPLE_CLOCK
ACQUISITION Toggles between internal clock and external clock.
SCDP SCREEN_DUMP
HARD COPY Initiates a screen dump.
SEQ SEQUENCE
AQUISITION Controls the sequence mode of acquisition.
*SRE *SRE
STATUS Sets the Service Request Enable register (SRE).
*STB? *STB?
STATUS Reads the contents of the IEEE 488.
STOP STOP
ACQUISITION Immediately stops signal acquisition.
STO STORE
WAVEFORM
TRANSFER
Stores a trace in internal memory or mass storage.
STPN STORE_PANEL
SAVE/RECALL Stores front panel setup to mass storage.
STST STORE_SETUP
WAVEFORM
TRANSFER
Sets up waveform storage.
TDIV TIME_DIV
ACQUISITION Modifies the timebase setting.
TMPL? TEMPLATE?
WAVEFORM
TRANSFER
Produces a complete waveform template copy.
TRA TRACE
DISPLAY Enables or disables the display of a trace.
TRFL TRANSFER_FILE
WAVEFORM
TRANSFER
Transfers ASCII files to and from storage media, or
between scope and computer.
*TRG *TRG
ACQUISITION Executes an ARM command.
TRCP TRIG_COUPLING
ACQUISITION
Sets the coupling mode of the specified trigger
source.
TRDL TRIG_DELAY
ACQUISITION Sets the time at which the trigger is to occur.