Manual
Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
87
Table of Commands and Queries — By Subsystem
S
HORT
F
ORM
L
ONG
F
ORM
W
HAT THE
C
OMMAND OR
Q
UERY
D
OES
ACQUISITION
—
T
O
C
ONTROL
W
AVEFORM
C
APTURE
ARM ARM_ACQUISITION
Changes acquisition state from “stopped” to “single.”
ASET AUTO_SETUP
Adjusts vertical, timebase and trigger parameters for signal display.
ATTN ATTENUATION
Selects the vertical attenuation factor of the probe.
BWL BANDWIDTH_LIMIT
Enables or disables the bandwidth-limiting low-pass filter.
COMB COMBINE_CHANNELS
Controls the channel interleaving function.
CPL COUPLING
Selects the specified input channel’s coupling mode.
FRTR FORCE_TRIGGER
Forces the instrument to make one acquisition.
ILVD INTERLEAVED
Enables or disables Random Interleaved Sampling (RIS).
MSIZ MEMORY_SIZE
Allows selection of maximum memory length.
OFST OFFSET
Allows vertical offset adjustment of the specified input channel.
RCLK REFERENCE_CLOCK
Toggles between internal clock and external clock.
SCLK SAMPLE_CLOCK
Toggles between internal clock and external clock.
SEQ SEQUENCE
Controls the sequence mode of acquisition.
STOP STOP
Immediately stops signal acquisition.
TDIV TIME_DIV
Modifies the timebase setting.
*TRG *TRG
Executes an ARM command.
TRCP TRIG_COUPLING
Sets the coupling mode of the specified trigger source.
TRDL TRIG_DELAY
Sets the time at which the trigger is to occur.
TRLV TRIG_LEVEL
Adjusts the level of the specified trigger source.
TRMD TRIG_MODE
Specifies Trigger mode.
TRPA TRIG_PATTERN
Defines a trigger pattern.
TRSE TRIG_SELECT
Selects the condition that will trigger acquisition.
TRSL TRIG_SLOPE
Sets the slope of the specified trigger source.
VDIV VOLT_DIV
Sets the vertical sensitivity in volts/div.
WAIT WAIT
Prevents new command analysis until current acquisition completion.
AUTOMATION
—
T
O
S
END
A
UTOMATION
C
OMMANDS
VBS VBS
Send Automation commands.
COMMUNICATION
—
T
O
S
ET
C
OMMUNICATION
C
HARACTERISTICS
CFMT COMM_FORMAT
Selects the format to be used for sending waveform data.
CHDR COMM_HEADER
Controls formatting of query responses.
CHLP COMM_HELP
Controls operational level of the RC Assistant.
CHL COMM_HELP_LOG
Returns the contents of the RC Assistant log.
CORD COMM_ORDER
Controls the byte order of waveform data transfers.