Manual
Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
89
S
HORT
F
ORM
L
ONG
F
ORM
W
HAT THE
C
OMMAND OR
Q
UERY
D
OES
MTPC? MT_PF_COUNTERS?
Returns pass/fail result.
MTST MT_SELECT_TEST
Selects Electrical Telecomm testing standard.
MTSY? MT_SYMBOL?
Returns 1 or 0 symbol, or pos or neg.
MTTS MT_TEST_STATE
Controls testing status: RUN, STOP, PAUSE, CONTINUE.
MTVA MT_VERTICAL_ALIGN
Performs offset alignment for STM-1E, STS-3E, and 139M.
FUNCTION — T
O
P
ERFORM
W
AVEFORM
M
ATHEMATICAL
O
PERATIONS
CLM CLEAR_MEMORY
Clears the specified memory.
CLSW CLEAR_SWEEPS
Restarts the cumulative processing functions.
DEF DEFINE
Specifies math expression for function evaluation.
FCR FIND_CENTER_RANGE
Automatically sets the center and width of a histogram.
FRST FUNCTION_RESET
Resets a waveform processing function.
HARD
COPY
—
T
O
P
RINT THE
C
ONTENTS OF THE
D
ISPLAY
HCSU HARDCOPY_SETUP
Configures the hard-copy driver.
SCDP SCREEN_DUMP
Initiates a screen dump.
MISCELLANEOUS
ACAL AUTO_CALIBRATE
Enables or disables automatic calibration
BUZZ BUZZER
Controls the buzzer in the instrument.
*CAL? *CAL?
Performs a complete internal calibration
COUT CAL_OUTPUT
Sets the type of signal put out at the CAL connector.
DATE DATA
Changes the date/time of the internal real-time clock.
DELF DELETE_FILE
Deletes a file from the currently selected directory.
DIR DIRECTORY
Creates or deletes directories, or changes the current directory.
MAIL EMAIL
Sets up email protocol and addresses.
*IDN? *IDN?
Used for identification purposes.
*OPT? *OPT?
Identifies the installed oscilloscope options.
*TST? *TST?
Performs internal self-test.
SAVE/RECALL
SETUP
—
T
O
P
RESERVE AND
R
ESTORE
F
RONT PANEL
S
ETTINGS
PNSU PANEL_SETUP
Complements the *SAV/*RST commands.
*RCL *RCL
Recalls one of five non-volatile panel setups.
RCPN RECALL_PANEL
Recalls a front panel setup from mass storage.
*RST *RST
Initiates a device reset.
*SAV *SAV
Stores the current state in non-volatile internal memory.
STPN STORE_PANEL
Stores the complete front panel setup on a mass-storage file.
STATUS
—
T
O
O
BTAIN
S
TATUS
I
NFORMATION AND
S
ET
U
P
S
ERVICE
R
EQUESTS
ALST? ALL_STATUS?
Reads and clears the contents of all (but one) of the status registers.
*CLS *CLS
Clears all the status data registers.
CMR? CMR?
Reads and clears the contents of the CoMmand error Register (CMR).
DDR? DDR?
Reads and clears the Device-Dependent error Register (DDR).
*ESE *ESE
Sets the standard Event Status Enable (ESE) register.