Datasheet

6
ZS SERIES ACTIVE PROBES
Teledyne LeCroy
Active Voltage Probe
Model Numbers:
ZS1000
ZS1500
ZS2500
ZS4000
The ZS Series probes are high impedance, low capacitance active probes that
maintain high signal delity through 4 GHz. A small form factor and a wide variety
of accessories ensures the ZS probe meets every difcult probing challenge.
Engineers must commonly probe high frequency signals with high signal delity.
Typical passive probes with high input R and C provide good response at lower
frequencies but inappropriately load the circuit and distort signals at higher
frequencies. The ZS Series features both high input R (1 MΩ) and low input C
(0.6 pF and 0.9 pF) to reduce circuit loading across the entire probe/oscilloscope
bandwidth. The ZS1000 is ideal for 200–600 MHz oscilloscopes. The ZS1500 is
ideal for 1 GHz oscilloscopes, the ZS2500 is ideal for 2 GHz oscilloscopes, and the
ZS4000 is ideal for 2.5 GHz and 4 GHz oscilloscopes.
PK-ZS-009
Copper Tape
PACC-PT005
Bent Tip
PK-ZS-024
2.54 mm PCB
Adapter
PACC-PT003
IC Tip
PK-ZS-017
Pogo Tip
PK-ZS-001
Probe Tip - Standard
PK-ZS-014
Y-Lead
Adapter
PK-ZS-010
Channel ID
Colored Clips
PK-ZS-019
Freehand Probe Holder
PK-ZS-023
Straight Pin
Lead - 13cm
PK-ZS-022
Straight Pin
Lead - 7cm
PACC-LD004
Right Angle
Pin Lead - 10cm
PK-ZS-007B
Microclip Sprung
Hook, Black
PK-ZS-007R
Microclip Sprung
Hook, Red
PK-ZF-025
QFPIC Clip Green -
Short
PK-ZF-025
QFPIC Clip Yellow -
Short
PACC-LD003
Right Angle
Pin Lead - 5cm
PK-ZS-006
Right Angle Socket
PK-ZS-021
Ground Blade -
Narrow
PK-ZS-015
Ground Blade - Wide
PK-ZS-016
Offset Ground
(Z Lead)
PK-ZS-020
Pogo Ground Lead
PK-ZS-018
2.54 mm Square
Pin Adapter
ZS4000