User manual

ZD Series Differential Probes
ZDSERIES-GSM-REVA
30
Safety Requirements
CAUTION
Avoid personal injury or damage to your accessory or any equipment connected to it by
reviewing and complying with the following safety precautions:
 Use only as intended. The accessory is intended to be used only with the compatible
LeCroy instruments. Use of the accessory and/or the equipment it is connected to in a
manner other than specified may impair the protection mechanisms.
 Connect and disconnect properly. Avoid damage through excessive bending of cables
and other equipment.
 Do not use in wet/damp or explosive atmospheres.
 For indoor use only. The accessory is intended for indoor use and should be operated in a
clean, dry, environment.
 Do not operate with suspected failures. Do not use the product if any part is damaged.
All maintenance should be referred to qualified service personnel.
 Keep product surfaces clean and dry.
 Completely assemble the measurement instrument before circuit/signal contact.
Connect probe to the measurement instrument before connecting the probe test leads to
a circuit/signal being tested.
 Do not apply a voltage to any input that exceeds the maximum rating of that input.
Refer to the Specifications on LeCroy website at www.lecroy.com for detailed
information.
 Be careful with sharp tips. Handle the probe with care as it has sharp tips that may cause
bodily injury if not handled properly.