User manual

Instruction Manual
ZDSERIES-GSM-REVA
7
Introduction
The ZD Series of Differential Probes (ZD500, ZD1000 and ZD1500) are high bandwidth active
differential probes. The probes feature low noise, very high input impedance and high common
mode rejection, and are ideally suited for signal integrity measurements in high-speed digital
systems.
With low input capacitance and high input resistance, circuit loading is minimized.
The ZD Series probes can be used with LeCroy’s WaveSurfer, WaveRunner, WavePro, and
WaveMaster series platforms with firmware version 6.4.1.x or later.
With the ProBus interface, the ZD Series probes become an integral part of the oscilloscope. The
probe can be controlled from the oscilloscope’s front panel. The oscilloscope provides power to
the probe, so there is no need for a separate power supply or batteries.
Key Benefits
The ZD Series probes feature:
 High frequency performance
 Low input capacitance
 Wide dynamic range
 ProBus interface
 A wide variety of tips, leads, and grabbers for probing
Standard Accessories
The ZD Series probe is shipped with the following standard accessories:
Standard Accessory
Quantity
Part Number
Straight Tip
4
PACC-PT001
Solder-in Lead
2
PACC-ZD002
Right Angle Connector (Long)
2
PACC-LD004
Micro-Grabber
2
PK006-4