User Guide

2102 Wireless Communication Module
Section 1 Quick Start Guide
1-3
Figure 1-2 2102 Components - Bottom View
1.2.2 Communication
Connectors
When a communication connector is not in use, the con-
nector must always be capped (Figures 1-3 and 1-5). The cap
will seal the connector to prevent corrosion, prevent moisture
from entering the unit, and improve communications.
When a communication connector is in use, store the cap on the
holder next to the connector (Figures 1-4 and 1-6). The communi-
cation connector will be sealed by its mating connector.
CAUTION
Caps PUSH ON and PULL OFF. Do not rotate the caps to
remove them from the connectors.
Note
For modules to correctly stack and lock together, protective
caps between the modules must be stored on the holders.
4
2
3
1
Table 1-2 Wireless Module Components - Bottom View
Item No. Description
1 Communication Connector
2Cap
3 Cap Holder
4 Latch