User guide

6200T Total Sulfur Analyzer Setup Menu
Teledyne Analytical Instruments 111
5.7. SETUP – COMM: Communications Ports
This section introduces the communications setup menu; Section 6 provides the setup
instructions and operation information. Press SETUP>ENTR>MORE>COMM to arrive
at the communications menu.
SAMPLE RANGE = 500.000 PPB SO2 =XXX.X
< TST TST > CAL SETUP
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SETUP X.X
COMMUNICATIONS MENU
ID INET COM1 COM2 EXIT
If the default password 818
is replaced by 000, then
Password Protection has
been enabled. Refer to
SETUP: PASS.
Figure 5-13: SETUP – COMM Menu
5.7.1. ID (Instrument Identification)
Press ID to display and/or change the Machine ID, which must be changed to a unique
identifier (number) when more than one instrument of the same model is used in a
multidrop configuration (0) or when applying MODBUS protocol (Section 6.6.1). The
default ID is the same as the model number; for the Model 6200T, the ID is 0100. Press
any button(s) in the MACHINE ID menu (Figure 5-14) until the Machine ID Parameter
field displays the desired identifier.