User guide

6200T Total Sulfur Analyzer Getting Started
Teledyne Analytical Instruments 77
3.4.2. Warning Messages
Because internal temperatures and other conditions may be outside the specified limits
during the analyzer’s warm-up period, the software will suppress most warning
conditions for 30 minutes after power up. If warning messages persist after the 60
minutes warm up period is over, investigate their cause using the troubleshooting
guidelines in Section 12.1.1.
To view and clear warning messages, press:
Figure 3-23: Warning Messages
SEL p-dF DIGITAL FILTER SET TO “5”
SEL P-SL LOWER LIMIT SET TO “32” (32C)
SEL P-SU UPPER LIMIT SET TO “1050” (1050C)
SEL P-AL ALARM TYPE2 SET TO “10”
SEL P-AH ALARM TYPE 1 SET TO “10”
SEL P-An HYTERESIS SET TO “3”
SEL
P-dP DECIMAL
LOCATION
SET TO “0”
SEL
PVOF PROCESS
OFFSET
LEAVE AT “0”
SEL SVOF SET POINT
OFFSET
LEAVE AT “0”
SEL
P-F
SET TO “ºC” (CENTIGRADE)
SEL FUZZY FUZZY LOGIC SET TO “ON”