user manual

Model9060ZManual

31


6.SETUPMODE
The SETUP mode is mode is accessed by pressing the SETUP key momentarily so the words ‘Setup
Mode’ appear at the bottom of the display. The transmitter will return to the RUN mode when the
SETUPkeyispressedagainor60secondsafterthelastkeypress.
6.1FUNCTIONSUMMARYTABLE
Whenthetransmitterisin theSETUP modethe SETUPlight willbeonandthewords“SetupMenu”
willbeshownatthebottomofthedisplay.
ThefollowingtableshowstheSETUPfunctions:

Menu# Functionname Range Defaultvalue
1 Probe1Offset ‐6.0to+6.0mV 0.0mV
2 Probe2Offset ‐6.0to+6.0mV 0.0mV
3 LowerLineItems SeeChapter6.3.2
4 OxygenDisplayUnits Oxygen%/Oxygenppm Oxygen%
5 DampingFactor NoDampingto10Samples 5Samples
6 ProcessAlarms Enabled/Disabled Disabled

6.2CHANGINGOPTIONS
The purpose of having a menu driven SETUP mode is to allow for configuration of the transmitter
usingthegraphicaldisplayandkeypad.
OnceanoptionischangedandenteredusingtheENTERkeythatvalueimmediatelybecomesactive.
It is also stored into the non‐volatile memory within the BBRAM and will be loaded again at device
start‐up.Toresetthetransmitterconfigurationdefaultsseechapter10.2,ColdStart.
TochangeanoptionintheSETUPmenusystem:
1. SelecttheSETUPmodebypressingtheSETUP/RUNkeyonce.TheSETUPlightwillcomeonand
thedisplaywillhaveth
eformatshownbelow.Theoperationsofthekeysarenowtheoperations
writteninWHITEonthekeypad.Themenunameiswrittenatthebottomofthedisplay.
2. When the SETUP mode has been selected the required function can be found by using the
FUNCTIONUPandFUNCTIONDOWNkeys.
The options available for that function can be seen by using the OPTION UP & OPTION DOWN
keys.
3. WhentherequiredoptionisonthedisplaypresstheENTERkeytosavethatvalue.
Whenfinished,presstheSETUP/RUNkeytoreturntotheRUNmode.



