User's Manual

Federal Communications Commission of the U.S. Government. These limits are part of

comprehensive guidelines and establish permitted levels of RF energy for the general

population. The guidelines are based on standards that were developed by independent

scientific organizations through periodic and thorough evaluation of scientific studies.

The standards include a substantial safety margin designed to assure the safety of all

persons, regardless of age and health.

The exposure standard for wireless mobile phones employs a unit of measurement

known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6

W/kg. * Tests for SAR are conducted with the phone transmitting at its highest certified

power level in all tested frequency bands. Although the SAR is determined at the highest

certified power level, the actual SAR level of the phone while operating can be well

below the maximum value. This is because the phone is designed to operate at multiple

power levels so as to use only the power required to reach the network. In general, the

closer you are to a wireless base station antenna, the lower the power

output. Before a phone model is available for sale to the public, it must be tested and

certified to the FCC that it does not exceed the limit established by the government

adopted requirement for safe exposure. The tests are performed in positions and

locations (e.g., at the ear and worn on the body) as required by the FCC for each model.

The highest SAR value for this model phone when tested for use at the ear is 0.95 W/Kg

and when worn on the body, as described in this user guide, is 0.66 W/ Kg. (Body-worn

measurements differ among phone models, depending upon available accessories and

FCC requirements). While there may be differences between the SAR levels of various

phones and at various positions, they all meet the government requirement for safe

exposure.

The SAR testing for Body-worn operation was performed with a belt clip that provided a

15mm separation. The User’s Manual indicates that any holsters/clips used with this

device should contain no metallic components.

The FCC has granted an Equipment Authorization for this model phone with all reported

SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR

information on this model phone is on file with the FCC and can be found under the

Display Grant section of http://www.fcc.gov/oet/ea after searching on U46-CDM2035.

Additional information on Specific Absorption Rates (SAR) can be found on the Cellular

Telecommunications Industry Association (CTIA) web-site at http://www.wow-com.com.

* In the United States and Canada, the SAR limit for mobile phones used by the public is

1.6 W/kg (W/kg) averaged over one gram of tissue. The standard incorporates a

sub-stantial margin of safety to give additional protection for the public and to account

for any variations in measurements.