User's Manual

Installing the Phone

The U1000 may be connected to either two 2-line (RJ14C) wall jacks or four single line (RJ11C) wall jacks to

accommodate all four lines. The U1100 does not require connection to telephone lines.

Choose an area near an electrical outlet and telephone wall jack. Your phone should be placed on a level

surface, such as a table top or desk.

Install 5 AAA-size alkaline batteries (not included) for backup power in the event of a power failure. To open

the battery door, find the tab on the top of the battery compartment. Push down on the tab and pull away

from the phone. A flat bladed screw driver may be needed.

Insert the batteries only as shown on the diagram

inside the battery compartment.

NOTE: If the low battery appears in the display, you will need to replace the batteries to ensure unit

operation during a power failure.

IMPORTANT: If you are no

t goin

g to use the telephone for more than 30 days, remove the batteries to avoid

battery leakage and damage to the unit.

Plug the AC power supply cord into the power jack on the back of the base and the other end into an

electrical outlet.

1. Connect the telephone line cords:

If you have two 2-line wall jacks installed in your home or office, plug

one end of the straight telephone linecord tagged as “Line 1+2” into

the jack marked “LINE 1+2” on the back of the U1000 base. Plug the

otherend of the line cord into the wall jack. Plug the other line cord into

If you have four single-line wall jacks installed in your home or office,

simply plug each single line cord intothe corresponding port on the back

of the U1000 base phone.

2. Connect the handset cord:

Connect one end of the coiled handset cord to the jack on the side

of the base and the other end into thejack in the handset, then place

the handset in the cradle.

Calls Ph.Book Menu

CAUTION: To reduce risk of personal injury, fire, or damage use only the T-T017(7.5V, 800mA)

For pluggable equipment, the socket-outlet (power adaptor) shall be installed near the equipment

and shall be easily accessible. Pour les appareils raccordés, la prise de courant (adaptateur

secteur) doit être installée près de l'équipement et doit être facilement accessible.

power adaptor listed in the user's guide. This power adaptor is intended to be correctly orientated

in a vertical or floor mount position. Unison system is a Class (Classe) 2 Power Source

the jack marked “LINE 3+4” on the back ofthe phone, with the other end

plugged into the wall jack as well.