User's Manual

1. If the battery door is attached, press on both sides of the battery compartment cover

andliftthecoverupando.

2. Insert the battery into the battery compartment with the warning label facing Up.

3. Push the battery plug into the connector inside the compartment according to the

color-coded label and place the wires neatly inside the compartment.

4. Insert the tab on the bottom of the battery cover into the battery compartment. Press

down gently on the battery cover until it snaps into place.

5. Place cordless headset in charger. Plug the power supply cord into the power jack on

the bottom of the charger and the other end into an electrical outlet. Place headset in

the charger. Within a few seconds, the charge indicator should illuminate, verifying the

battery is charging.

6. Allow the unit to charge for 14 hours prior to rst use. If you don’t properly charge the

unit, battery performance may be compromised.

NOTE: Remove the ear hook from the headset before battery replacement.

HEADSET SET UP

Headband Attachment

Attaching the headset to the headband:

1. Remove ear hook if currently attached to the headset.

2. Insert the earpiece into the headband ring.

3. Push the earpiece towards the headband ring

until it clicks into place.

4. Adjust the headband to t your head comfortably.

Adjust and rotate the angle of the headset until the

microphone is pointing toward your mouth.

NOTE:

To wear on the other ear, rotate the headset within the headband ring.

Firmly grip the padded earpiece with one hand, adjusting the headset microphone up or

down . To remove the headset from the headband, hold the headset with one hand and the

headband ring with the other hand. Twist and pull the headset gently until it separates

from the ring of the headband.

NOTES:

When you use the headband, you can use the highest in ear tip to keep the volume state.