User's Manual

About Pairing Codes

The Parent Unit(s) and Child Unit are digitally “paired” at the factory. This means they are digitally

encrypted with the same electronic code so that they can securely communicate with each other and

not be confused by the signals sent out by other electronic devices, such as cell phones or other monitors.

It is unlikely, but possible, that strong electronic interference, such as a power surge, could erase this

coding. Should this occur, you can reset the pairing codes by following these steps:

To reset pairing codes:

1. Turn off the Parent Unit, and remove the belt clip/stand (use a small screwdriver to loosen the

holding screw).

2. Turn off the Child Unit.

3. Position the two units close together (within 3 inches).

4. Insert the end of a paper clip into the reset hole on the Child Unit.

5. Turn on the Child Unit and immediately firmly push the paper clip down and hold. Release once both

power and connection indicators start blinking. It is critical that both indicators are blinking. If this

does not happen, repeat steps 2 - 5 again.

6. Turn on the Parent Unit.

7. Insert paper clip into the reset hole on the Parent Unit, firmly push the paper clip down and release.

8. Both Units will go into regular operation mode once pairing is complete.

If this does not happen repeat steps 1 - 7.

9. If you have A200, repeat steps 1-8 for second Parent Unit.

NOTE: This pairing operation could take up to 60 seconds.

If this operation does not restore monitor functionality, please contact Customer Service at 1-800-704-8697.

ESET