User's Manual

10
About Pairing Codes
The Parent Unit(s) and Child Unit are digitally
“paired” at the factory. This means they are
digitally encrypted with the same electronic code
so that they can securely communicate with each
other and not be confused by the signals sent out
by other electronic devices, such as cell phones or
other monitors.
It is unlikely, but possible, that strong electronic
interference, such as a power surge, could erase
this coding. Should this occur, you can reset the
pairing codes by following these steps.
To reset pairing codes:
1. Turn off the Parent Unit(s), and remove the belt
clip/stand (use a small screwdriver to loosen the
holding screw).
2. Turn off the Child Unit.
3. Position the two units close together
(within 3 inches).
4. Insert the end of a paper clip into the reset hole
on the Child Unit.
5. Turn on the Child Unit and immediately firmly
push the paper clip down and hold. Release
once both power and connection indicators start
blinking. It is critical that both indicators are
blinking. If this does not happen, repeat
steps 2 - 5 again.
6. Turn on the Parent Unit.
7. Insert paper clip into the reset hole on the
Parent Unit, firmly push the paper clip down and
release.
8. Both Units will go into regular operation mode
once pairing is complete.
If this does not happen repeat steps 1 - 7.
9. If you have P400, repeat steps 1-8 for second
Parent Unit.
NOTE: This pairing operation could take up to
60 seconds.
If this operation does not restore monitor
functionality, please contact Customer Service
at 1-800-704-8697.
Care
To Clean:
Do not immerse the parent unit(s) or the child
unit in water. Do not use cleaning spray or liquid
cleaners.
1. Unplug the child and parent unit(s) if they are
connected to a power source.
2. Clean the child and parent unit(s) with a damp
cloth. Make sure they are dry before
re-connecting them to a power source.
3. Unplug the adaptors and clean them with a dry
cloth.
4. Dispose of used batteries in an environmentally
friendly manner.
5. If the baby unit is connected to a power supply,
check its batteries for leakage every six months.
Storage
When you are not going to use your True Choice
™
monitor for some time, remove the alkaline
batteries from the child unit and remove the
rechargeable batteries from the parent units(s).
Store in a clean, dry place.