User's Manual

5
To Set Up - Parent Unit(s)
1. Loosen the screw to release the battery
compartment cover. Then, lift the cover off.
(For easier access, press on the top of the
belt clip/stand to hold it out of the way.)
2. Insert the plug on the battery pack into the
connector inside the battery compartment.
Note: Align raised rib on plug with slot in
connector.
3. Fit the battery pack into the compartment;
be certain that the side with the battery
information faces up. Press battery pack
firmly into place.
4. Place the cover back onto the battery
compartment and secure it by tightening the
screw.
5. Charge the battery: Insert the connector on the
AC adaptor into the jack on the bottom of the
unit, and plug into an electrical outlet. The
battery needs to be charged for 8 hours before
the first portable use.
IMPORTANT: While the battery is charging, the
power indicator will glow purple. Once the
battery is fully charged it will glow blue steadily.
You may use the monitor while charging;
however, it will take longer to charge when in
use.
To install batteries For plug-in use/recharging
Reconnect the Parent Unit to the AC adaptor as for
initial battery charging and plug the adaptor into an
electrical outlet. If desired, open stand to support
unit in an upright position.
IMPORTANT: Use only the AC adaptors supplied
with this product. Use of any other adaptor(s) could
damage Monitor and would void warranty.
: Product is not intended for use by children under
3 years old;
: Product must only be used with the
supplied AC adaptor;
: AC adaptor is not a toy;
: AC adaptor should be regularly examined for
damage to the cord, plug, enclosure or other
parts, and in the event of such damage, it must
not be used until the AC adaptor has been
replaced.
To obtain replacement AC adaptor: please call our
Parent Service Center at 800-704-8697.
WARNING:
Batteries may explode or leak if not used correctly. Follow all instructions for proper
installation, use and storage.