Operation Manual

Setting clock
1. Press the CLOCK button on the unit twice, then the hour number will flash.
2. Set the hour number by pressing the
/ CH+ (on the remote control ) button or the / CH- (on the
remote control
) button.
3. Press the CLOCK button on the unit, then the minute number will flash.
4. Set the minute number by pressing the
/ CH+ (on the remote control ) button or the / CH- (on the
remote control
) button.
5. Press the CLOCK button again, then the time has been set, and the second will be calculated from zero.
NOTE:
¾ You can set the clock while the unit is in STANDBY mode.
¾ If an electricity blackout occurs or somebody cuts off the power supply, the clock will lose the preset time.
Troubleshooting
If breakdown occurs, please check the system according to this table and try and ascertain the possible problem. If you
still can’t solve the problem, please contact an authorized service agent to repair it as soon as possible.
Problem Possible reason Possible solution
No sound
Wrong connection or loose
connection.
System mute.
Check and correct all the
connections.
Cancel mute if active.
Bad radio
reception effect
Antenna not connected properly.
AM annular antenna too close to the
system.
FM linear antenna not in a suitable
place.
Connect the antenna properly.
Change the position and direction of
AM antenna.
Unfold the FM antenna and move
around until better reception
received.
Disc playing
abnormal
Disc dirty or scratched. Clean or change disc.
Disc not playing Disc placed upside down.
Turn the disc over with the label
side facing up.
Remote control
not working
There is an obstruction between
remote control and the sensor on
the unit.
Flat battery.
Distance too far away from unit.
Clear away obstructions.
Change batteries.
Operate closer to unit.
Can’t operate
system
External interference causing the
CPU not to work.
Pull out the plug and insert again.
NOTES:
1. Please read this operation manual carefully before you operate this unit. Keep it in a safe place for future reference.
2. When you want to cut off the electricity supply of the whole unit’s power, press the POWER button on the rear panel
of the unit. The STANDBY button can only make the unit standby, it can’t switch off the unit.
3. If you are not going to use your unit for a long period of time. Set the main POWER button on the back of the unit to
“OFF”, and take out the remote control battery to avoid any damage from battery leakage.
4. Be cautious where the safety mark “
“ appears.
5. If something is not operating correctly, please send to an authorized service agent to repair. Don’t take it apart
yourself.
6. Because of a sudden change in temperature or humidity, or when warm air comes into contact with any cold parts in
the unit, condensation may form. When condensation forms inside, the unit may not function properly. Once
condensation disappears, the unit will return to normal functioning. Placing the unit in a warm room will help to dry up
condensation. This should take 1 to 2 hours, depending on environmental conditions. As condensation may also
appear on the disc, it should be wiped from the center of the disc towards the outer side using a soft dry cloth.