User's Manual

ETRX358x-LRS and ETRX358x-LRS
©2014 Telegesis (UK) Ltd - 7 - ETRX358x-LRS Product Manual
2 Product Approvals
The ETRX358x-LRS and ETRX358xHR-LRS have been designed to meet all national regulations
for world-wide use. In particular the following certifications have been obtained:
2.1 FCC Approvals
The Telegesis ETRX358x-LRS family with integrated Antenna as well as the ETRX358xHR-LRS
family including the antennas listed in able 2 and the power levels listed in section 10.2 have been
tested to comply with FCC CFR Part 15 (USA) The devices meet the requirements for modular
transmitter approval as detailed in the FCC public notice DA00.1407.transmitter.
FCC statement:
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
This module complies with the USA SAR requirements and is not intended to be operated within
20cm of the body. The following statement must be included as a CAUTION statement in manuals
for OEM products to alert users on FCC RF exposure compliance
“WARNING: To satisfy FCC RF exposure requirements for mobile transmitting devices, a
separation distance of 20cm or more should be maintained between the antenna of this
device and persons during operation. To ensure compliance, operations at closer
distances than this are not recommended.”
Item
Part No.
Manufacturer
Type
Impedance
Gain
1
BT-Stubby
(straight)
EAD Ltd. [6] ¼ Wave
50Ω
0dBi
2
BT-Stubby
(right-angle)
EAD Ltd. [6] ¼ Wave
50Ω
0dBi
3 CJ-2400-6603 Chang Jia ½ Wave 50 Ω 2.0dBi
4
Rufa (on
board)
Antenova Chip
50Ω 2.1dBi
(peak)
Table 2. Approved Antennae
An end user deploying an ETRX358x-LRS or an ETRX358xHR-LRS module together with an
antenna as listed in Table 2 is not required to obtain a new authorization for the module – BUT this
does not preclude the possibility that some other form of authorization or testing may be required
for the end product depending upon local territorial regulations.
The FCC requires the user to be notified that any changes or modifications made to this device
that are not expressly approved by Telegesis (UK) Ltd. may void the user's authority to operate the
equipment.
When using the ETRX358x-LRS with approved antennae, it is required to prevent end-users from
replacing them with non-approved ones.
FCC ID
:
S4
GEM358L