User Manual

DTR4000CA Menu Operation
asked for new PIN Code. You enter new PIN code, and the system re-asks you to repeat
the PIN Code. If you enter the new PIN Code again, then the PIN code is permanently
changed.
** Be sure not to forget the PIN code. If you forget the PIN Code, you have to
contact the distributor to clear up the problem
Receiver Update
 At the moment, the DTR4000CA can be upgraded via RS-232C cable from the PC. The
upgrade software can be downloaded from the manufacturer’s web site.
“Http://WWW.Telemann.com".
 Upgrade through Satellite will be added later.
Auto Installation
Based on the Satellite and Transponder information attached at the end of this
manual, DTR4000CA automatically sets all channels from a Satellite. This
information may change from time to time. When you cannot receive any signal
from any satellite or transponder, check the information of those satellite or
transponder.
 Select the Auto Installation from the MAIN menu.
LNB Selection From LNBs that you set up in LNB Setup menu, select
one LNB.
Region Selection Selects from Europe, Asia, or America based on where
the DTR4000CA is used.
Satellite Selection Select the satellite that you wants.
 After you set up the above three menus, press “OK”. Then, DTR4000CA will
start to automatically search and set channels. To search the whole satellite, It
will take time.
 The Factory Default Satellite information is listed in Annex “Factory Default
Satellite Information”. This satellite information can be updated. For upgrade,
please refer to the manufacturer’s web site.