User's Manual

DRAFT

RSC-900

Road Side Communicator

User Manual

NOTE:

This equipment has been tested and found to comply with the limits

for a Class A digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment

in a residential area is likely to cause harmful interference in which

case the user will be required to correct the interference at his own

expense.

PAGE 1
DRAFT RSC-900 Road Side Communicator User Manual NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
PAGE 2
DRAFT Installation & Operation instructions The RSC-900 should be installed by professional installers ONLY authorized ONLY by the local distributor – the “Operating Company” The RSC has to be installed on a horizontal pipe above the center of a road lane. The pipe has to be 1.5” up to 2” in diameter, and its length has to be sufficient to locate the RSC over the center of the lane. (The width of a standard lane is about 3.6m).
PAGE 3
DRAFT U stretchers RSC cable connection 1. Connect the RSC Cable to RSC connector RSC Connector RSC cable Antenna Cable The RSC-900 is delivered with a connected antenna. Do not remove or change the antenna cable connections. The use of any antenna other than the one being an integral part of the RSC-900 is expressly forbidden in accordance with FCC rules CFR47 part 15.204.
PAGE 4
DRAFT Power and communication connections • Connect the main power (24 V) to the RSC cable to pins No 23/24 (+) and pins No.
PAGE 5
DRAFT We will be happy to assist you at operating support center Tel: Fax: “Operating Company” Name Logo and address DRAFT