User's Manual

Tnet 210 Installation Instructions Rev 1.0 January 13, 2013 Page 1 of 3

Tnet 210 Module

Installation

Instructions

FCCID:NTAT210



January13,2013

Rev1.0

PROPRIETARY INFORMATION

ALL RIGHTS RESERVD, NO PARTS OF THIS DOCUMENT MAY BE REPRODUCED,

STORD IN RETRIEVAL SYSTEM, OR TRANSMITTED IN ANY FORM OR BY ANY

MEANS, ELECTRONIC, MECHANICAL PHOTOCOPYING, RECORDING OR

OTHERWISE WITHOUT THE PRIOR WRITTEN PERMISSION OF TELEMATICS

WIRELESS LTD. NOR USED IN WHOLE OR IN PART FOR ANY PURPOSE OR FOR

ANY CUSTOMER EXCEPT TELEMATICS WIRELESS.

PAGE 1
Tnet 210 Module Installation Instructions FCC ID: NTAT210 January 13, 2013 Rev 1.0 P R O PR I ETA R Y INF O R M A T ION ALL RIGHTS RESERVD, NO PARTS OF THIS DOCUMENT MAY BE REPRODUCED, STORD IN RETRIEVAL SYSTEM, OR TRANSMITTED IN ANY FORM OR BY ANY MEANS, ELECTRONIC, MECHANICAL PHOTOCOPYING, RECORDING OR OTHERWISE WITHOUT THE PRIOR WRITTEN PERMISSION OF TELEMATICS WIRELESS LTD. NOR USED IN WHOLE OR IN PART FOR ANY PURPOSE OR FOR ANY CUSTOMER EXCEPT TELEMATICS WIRELESS.
PAGE 2
CAUTION The User and the Installer should be aware that changes and modifications to the equipment not expressly approved by Telematics Wireless could void warranty and the user's authority to operate the equipment. Professionally trained personnel should install the equipment.
PAGE 3
Tnet 210 Module Installation Instructions Tnet 210 Module is installed on the carrier board and connected to external antenna using special antenna cable. 1. Make sure that the carrier board power is off. 2. Connect Tnet 210 Module to the carrier board using board to board connectors and plastic spacers. 3. Connect antenna cable to the Tnet 210 Module antenna's connector.