CAUTION! • Never install telephone wiring during a lightning storm. • Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. • Never touch uninstalled telephone wires or terminals unless the telephone line has been disconnected at the network interface. • Use caution when installing or modifying telephone lines.
Congratulations on the purchase of your TeleMatrix Spectrum PLUSTM model SP100 telephone. The Spectrum PLUSTM SP100 includes advanced features that are suitable in today’s business environment. TeleMatrix designed the Spectrum PLUSTM SP100 to be simple to install and easy to use. Your Spectrum PLUSTM SP100 telephone is a precision electronic device that requires minimum maintenance. Please be sure to read this user’s guide to become familiar with the wiring and functionality of this product.
Features ......................................................................... 5 Controls ……..................................................................... 6 Part List …………………………………………………………………………………... 10 Installation ..................................................................... 11 Wall Mounting ............................……................................ 12 Switch Settings ..................….….......................................
• One Line Operation • Visual Message Waiting Indication; 90VDC NEON or Low Voltage LED; Switch Selectable* • Electronic Hold with LED Indicator • HI/LOW/OFF Ringer Volume Control Switch • Disconnect Key to Activate New Call • Last Number Redial • Flash Key • Convenient Data Port • ADA Compliant Handset with Volume Control • Desk or Wall Mountable • Fully Modular, Easy To Install *Visual Message Waiting are features that require subscription to your local telephone company or PBX provi
TOP PANEL (7) (8) (1) TURN (4) (2) (3) (5) 6 (6)
1. Disconnect Key ……………………...…….. Used to disconnect the line or place a new call. 2. Redial Key ......................…………… Redials the last number dialed. 3. Flash Key ..................……………..…. Provides a timed line break. 4. Numeric Dial Pad ………………...………. Used for dialing. 5. Hold Key ………………………………..…….. Lighted key used for placing callers on hold. 6. Volume Bar …………………..………………. Adjusts the loudness of the handset receiver. 7. Handset Hearing-aid compatible handset. 8.
LEFT SIDE RIGHT SIDE REAR (4) (5) (6) (1) (2) (3) 8
1 Data Port .................................... Convenient port to connect a computer, modem, fax or answering device. 2 Line Jack ………………………………………... Modular receptacle for connecting the line cord. 3 Handset Jack .............................. Connection for handset coil cord. 4 Message Waiting Selector Switch … Selects low voltage message waiting or 90VDC. 5 Ringer Volume Control Switch …….. Used to control the ring volume HI/LOW/OFF. 6 Elevation Stand Lock …………………….
Parts Check List The following parts are included with the Spectrum PLUSTM SP100: 1. 2. 3. 4. 5. 6. Base Unit Handset One (1) 15-foot Modular telephone line cords 10-foot Modular coiled handset cord 6-inch Modular wall mount line cord Two (2) Index Sheets 2. Tear in dex pap er fr om the index she et. 1. Clear p lastic overlay be ing re mov e fr om the index ca rd ar ea on the teleph one. 2 1 3. Lif t off clear p lastic keycap and inser t the paper key label.
Connecting the Handset Cord A 10-foot modular coil handset cord is provided. (Be sure that the wall/desk elevation stand has not been attached). To install the cord, simply plug the short end of the handset cord into the modular jack on the handset. The long end of the handset cord plugs into the jack labeled “Handset” located on the bottom of the Spectrum PLUSTM base unit. Place the line cord into the handset coil cord channel located directly below the jack. Connect the Line Cord.
Wall Mounting the Spectrum PLUSTM Telephone The Spectrum PLUSTM was designed to be conveniently wall mounted without requiring additional hardware. Follow these easy steps: 1.The handset retaining clip must be in the correct position to secure the handset into the handset cradle. Engage the clip with your fingers and pull the clip forward (towards you), rotate the clip 180º and snap the clip back into place (figure 1). The retaining clip cannot be removed. 2.
Message Waiting Light Indicator The Spectrum PLUSTM telephone has a Message Waiting (MW) Light Indicator (figure 1). The indicator will blink to indicate that a new message is in the user’s voice mailbox. The Spectrum PLUSTM supports the following telephone or PBX supplied message waiting signals: 1. 90-Volt NEON message waiting light indicator signal provided by a PBX. 2. Low Voltage LED message waiting light indicator light signal is provided by a PBX.
Message Waiting Selector The SP100 supports either 90VDC neon or low voltage LED message waiting systems. Position the NEON/LED switch to the desired position so that the telephone is compatible with your PBX message system. Note: the phone is factory preset to the “NEON” setting. Ringer Volume Control The switch is located at the back of the telephone. The switch has HI/LOW/OFF setting. Place the switch in the position for the desired ring volume or off. Note: The switch factory “HI” position.
Hold Key Indicator When the “HOLD” key is activated, the light above the HOLD KEY will be steadily RED. Using the Hold Feature The “HOLD” key is used to place a caller on hold. To use, simply press the “HOLD” key. When the “HOLD” key is active, the handset can be lifted off-hook or returned to its on-hook position and the line will not be disconnected. To return to the caller, simply lift the handset. Hold will also release when the call is picked up from an additional extension phone.
Using the Redial Feature The “REDIAL” key is used to automatically redial the last number that was dialed from the keypad. To use: • • • Lift the handset. Press the “REDIAL” key. The last number dialed will be redialed. Flash Function The “FLASH” key is a 600mS electronic timed line break that is used for accessing line features provided by your telephone company or by your telephone system.
Using The Disconnect Feature Key The “DISC” (DISCONNECT) key is a 2-second electronic timed line break. The key can be used to automatically hang-up the call that you are currently on and regain a new dial tone to establish a new call. To use: • Simply press the “DISC” key when the conversation is complete. Handset Volume Control The Spectrum PLUSTM is equipped with an ADA/FCC compliant handset volume control located on the front of the phone.
Keep the telephone dry. If it gets wet on the outside, wipe it dry immediately. Liquids might contain minerals that can corrode the electronic circuits. Do not touch the unit if submerged in water. Call for assistance. Use and store the telephone only in normal temperature environments. Temperature extremes can shorten the life of electronic devices, damage batteries, and distort or melt plastic parts. Avoid direct sunlight.
When problems arise during installation or service that cannot be resolved using this or related documents, contact the TeleMatrix Priority Care Department, Monday through Friday, 8:30a.m. - 4:30p.m. MST: Toll Free: 1-800-462-9446 Direct: 719-638-8821 Fax: 719-638-8815 www.telematrixusa.com Many times a problem is either installation or user related. Please contact TeleMatrix PRIOR to sending a telephone to our service center for repair. In the unlikely event that a factory repair is necessary: 1.
STATEMENT OF LIMITED WARRANTY TeleMatrix, Inc.
