Datasheet

Product datasheet
Characteristics
XXS18S1PM12
Ultrasonic sensor cylindrical M18 - Sn=1m - PNP -
SYNC - connector M12
Main
Range of product
OsiSense XX
Sensor type
Ultrasonic sensor
Series name
General purpose
Sensor name
XXS
Sensor design
Cylindrical M18
Detection system
Diffuse
[Sn] nominal sensing distance
1 m adjustable with remote teach push-button
Material
Metal
Type of output signal
Discrete
Discrete output function
1 NO or 1 NC programmable
Wiring technique
5-wire
Discrete output type
PNP
[Us] rated supply voltage
12...24 V DC with reverse polarity protection
Electrical connection
Male connector M12 5 pins
[Sd] sensing range
0.105...1 m
IP degree of protection
IP67
IP65 conforming to IEC 60529
Complementary
Enclosure material
Stainless steel 316L
Front material
Epoxy
Rubber
Resin
Supply voltage limits
10...30 V DC
Function available
With synchronisation mode
Software configurable
[Sa] assured operating distance
0.105...1 m (teach mode)
Maximum differential travel
4 mm
Blind zone
105 mm
Transmission frequency
200 kHz
Repeat accuracy
0.1 %
Deviation angle from 90° of object to be detected
-7...7 °
Minimum size of detected object
Cylinder diameter 1 mm at 600 mm
Status LED
1 LED (yellow) for output state
1 LED (green) for echo state
Current consumption
30 mA
Maximum switching current
100 mA with overload and short-circuit protection
Voltage drop
<= 2 V
Switching frequency
11 Hz
Setting-up
Teach mode
Delay first up
<= 120 ms
Delay response
<= 45 ms
Delay recovery
<= 45 ms
Marking
CE
Threaded length
45 mm
Height
18 mm
Width
18 mm
Depth
64 mm
The information provided in this documentation contains general descriptions and/or technical characteristics of the performance of the products contained herein. This documentation is not intended as a substitute for and is not to be used for determining suitability or reliability of these products for specific user applications. It is the duty of any such user or integrator to perform the appropriate and complete risk analysis, evaluation and testing of the products with respect to the relevant specific application or use thereof. Neither Schneider Electric Industries SAS nor any of its affiliates or subsidiaries shall be responsible or liable for misuse of the information contained herein.
1 / 5