User's Manual

Section 4 – Installation Procedure (Continued)
15
8. Turn transmitter ON. Check to see if the
yellow LED is now lit (DSMR1). At this
point the MR relay is disabled, the functions
of the transmitter can be checked by noting
the turning ON of the appropriate red LEDs
next to the control relays (DS7 to DS11).
After checking out the functions, turn switch
SW2 ON to enable the MR relay, check
function and direction by jogging each
motion. Installation should now be
complete.
9. If there are any problems see Section 8.
Servicing.
Figure 4-1. Input Power Connections.
GND N 120V
J1
1
Figure 4-2A. Receiver Mounting Details with
Horizontal Mounting Brackets.
Drawing not to scale.
12.02”
305.3 mm
16.02”
406.9 mm
7.87”
200 mm
Receiver shown with
MP10278-0 mounting
brackets attached.
.210” DIA.
5.34 mm
hole 4 places
11.02”
279.9 mm
.281” DIA.
7.14 mm
hole 4 places
11.81”
300 mm
Overall Cabinet Depth With door
closed inches
With door
closed mm
With door
open inches
With door open
mm
Cabinet 5.26 133.60 12.12 307.98
Cabinet and mounting bracket 5.44 138.07 12.30 312.44
Cabinet, mounting bracket & 1 ½” strut 6.94 176.17 13.80 350.54
14.02”
356.01 mm
7.09”
180 mm