User's Manual

Section 7 – Programming
48
7-1. Access Code Programming.
7-1.1. Programming Access Codes.
The access code is set at the factory and should
not be changed unless absolutely necessary. If
you are reprogramming a spare or new
transmitter make sure the other transmitter is
securely taken out of service.
Also a label on the transmitter lists the access
code settings inside. The positions on the
transmitter label match the switch settings. The
“1” by A1 means the switch position A1 should
be ”ON” and “0” means A1 should be “OFF”.
NOTE
FOR THE MEMBRANE, PENDANT
TRANSMITTER AND RECEIVER. DO NOT
USE A PENCIL TO TOGGLE THE
SWITCHES. THE LOOSE GRAPHITE FROM
THE PENCIL CAN DAMAGE THE SWITCH.
WARNING
TWO OPERATIONAL TRANSMITTERS
WITH THE SAME ACCESS CODES OPER-
ATING AT THE SAME TIME IS A DEFINITE
SAFETY HAZARD. FAILURE TO FOLLOW
THIS WARNING COULD RESULT IN
SERIOUS INJURY OR DEATH AND
DAMAGE TO EQUIPMENT.
7-1.2. Changing Transmitter Access Codes.
7-1.2.1.
tele
Pilot
Access Code Programming.
For detailed instructions on setting parameters
including access codes see Section 7-8. teleP
ilot
Programming.
7-1.2.2. Membrane Transmitter Access Code
Setting.
Open the back battery door and take out the
batteries as a safety precaution.
Remove the 6 screws on the front cover. Lift out
switch-pad, logic board and turn logic board
over.
Locate the dip switches marked “A” and “B”.
See Figure 8-3. Membrane Transmitter M/C
Module E10635. With a pen or pointed object
toggle the switches to match the Access Code on
Figure 7-1. Access Code Setting.
(A dot on a switch position or a “1” in the
label is an indication that the respective
switch position should be ON).
Sample Membrane or Pendant Transmitter
Access Code Label
Sample access code only do not use
SW1
Membrane
Transmitter
Pendant Transmitter
SW1
OFF
1 A 8
ON
OFF
ON
8 B 1
MODEL # -10KXXXXXXXX
S/N=XXXXXXXXXXXXXXXXX
ACCESS CODE SETTING
1 A 8 1 B 8
0 1 0 0 0 1 1 1 0 1 1 0 0 0 1 0
FREQ : = AK01 J # = XXXXX
Access Code Switches
Sample access code only, do not use
SW2
ON
ON
SW1
8 A 1
OFFOFF
8 B 1
TR12 Receiver
ON
8 A 1
SW2
OFF
8 A 1
1 B 8
OFF
ON
SW2
OFF
A1
tele
Pilot
Transmitter
1 A 8
ON
OFF
1 B 8
ON
OFF
B1
Receiver access code
1
0
1
0
Indicates switch in OFF position