User's Manual

Section 7 - Programming (Continued)
66
10K
tele
Pilot
Programming (Continued).
7-8.1.1.
Single-Speed 10K
tele
Pilot
Only:
Skip to next section7-7.1.2 (below) if 2-speed.
Timer (If unsure of a number start with 15 minutes):
Enables the transmitter time-out-timer. The selections
are “None” (meaning the transmitter will never shut off
on it own if not used, this is not recommended for
battery life) or numbers of minutes till shut down. The
minutes are selectable in one-minute steps from 1 to 10
and five minutes steps up to an hour. Tap on the “Timer”
arrow; scroll down through the number of minute and
tap on the desired number.
Modes 1-3 (The correct mode must be selected for
safe operation):
Please refer to
Figure 7-7. Single-Speed 10K
tele
Pilot
for specific mode details. Modes are various patterns of
functional lockouts. If you have UP and a DOWN
buttons on a single-speed transmitter controlling a hoist,
the transmitter must not be able to send Up and DOWN
commands at the same time.
Mode determines the respective buttons that are locked
out to each other. Modes do NOT change the
configurations of the output relays. Find the desired
mode and select its number on the “Mode” selection.
This completes the 10K single-speed programming,
when completed with the above tap “Save”.
Save will take you back to the initial start screen and
turn the Bank ON. At this point select another Bank to
program or go to Section 7-9. Loading And Saving The
Program.
10K
tele
Pilot
Programming (Continued).
7-8.1.2.
2-Speed 10K
tele
Pilot
Only:
Programming Switch S3-1
NOTE
IF REPLACING A MEMBRANE OR PENDANT
TRANSMITTER, YOU CAN COPY THE SWITCH
SETTINGS ON THE EXISTING TRANSMITTER.
Membrane:
Copy Switch 3 (all positions) settings on
the Membrane transmitter to S3 on the PDA.
Pendant:
Copy Switch 3 (positions 1, 2, 3 and 8)
settings on the Pendant transmitter to S3 (positions 1, 2,
3 and 8 respectively) on the PDA. Copy Switch 4
(positions 5, 6 and 7) settings on the Pendant transmitter
to S3 (positions 5, 6 and 7 respectively) on the PDA. If
Switch 4 on the Pendant transmitter has positions 1 and
or 2 Switched ON see the write-up on Main/Aux Menu
below. If SW4 position 3 is switched “ON” un-check
Tandem box on PDA. If SW4 position 4 is switched
“ON” check Invert box on PDA.
10K Single-Speed
Programming Screen
System 10K Freq AK01
Setup Bank #
A1
Receiver access code
1
0
B1 1
0
Multibox Tx # 1
Auto Turn Off
Timer None
Mode 1
Save
Cancel
System 10K Freq AK01
Setup Bank #
A1
Receiver access code
1
0
B1 1
0
Multibox Tx # 1
Auto Turn Off
S3-1
1
0
Timer
Switch conf.: H,T,B
Main/Aux Aux
Save
Cancel
10K 2-Speed
Programming Screen
A detailed table of Transmitter switch programming
versus
tele
Pilot
is in Appendix A.