User's Manual

Section 7 - Programming (Continued)
75
Reading The
tele
Pilot
ID.
To read an identity (an identity is the name that was
programmed in by step 5 of Sending a Program To The
tele
Pilot
, listed above) from the tele
Pilot
Transmitter:
1. Line up the PDA’s infrared port as sets 1 to 3
above, with the transmitter ON. Select “Admin”
2. Select “tele
Pilot
ID.”
3. PDA will read: Name, Serial/Job Number, and
Manufacturing information of the tele
Pilot
unit.
Reading The
tele
Pilot
History.
To read Service information from the tele
Pilot
Transmitter:
1. Line up the PDA’s infrared port as sets 1 to 3
above, with the transmitter ON. Select “Admin”
2. Select “History”
4. Unit will read: Past Service Orders of the
tele
Pilot
unit.
Reading The PDA
tele
Pilot
Software Version.
To read PDA Software Version from the tele
Pilot
Transmitter:
1. Select “Admin”
2. Select “About”
3. Unit will read: tele
Pilot
Programmer Software
Version number.
Beaming (Sending) the Configuration(s) to another
PDA.
To send a configuration setting to another PDA.
1. Line up the PDA’s infrared port as, with the
other PDA, which is turned ON.
2. Select “Beam Setting.”
3. Select the item(s) you wish to send.
4. Wait for confirmation text on PDA screen:
Error Statements and Codes.
Tx Type Mismatch; If while attempting to program a
tele
Pilot
you receive an error code such as “Error
AAAB” you have selected a different style transmitter
on the PDA than you are attempting to program. Most
common cause is trying to program a 2-speed tele
Pilot
with single-speed selected or visa versa.