User's Manual

X3 User manual
1Safety Warning and Transportation Safety
Safety Warning
For correct and safe use, please read the safety warning carefully and follow all the
instruction .
When forbidden using wireless device or device use would interrupt electronic
device and safety potential , please turn off the power supply .
In flammable and explosive area, please turn off the power supply, and follow the
related instruction, so as not to cause explosion or fire. Flammable and explosive
area include but not limited in: gas station, fuel section (like: capsule under the ship
deck), flammable or heavy chemicals transport and store device, with explosive
danger mark area, area with the mark of "turn off the twoway wireless electronic
device"
Transportation Safety
When flying on plane , please follow the rule of airline. Turn off the power supply
before the taking off of plane, to avoid the potential risk
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

Summary of content (4 pages)