Operation Manual
Installing the TELES.iTA/2TR Box
© 1998 by TELES AG Berlin, Version 1.30/iTA-eu/f/8.02 Issue: June 1998 Page 5
3.2 Required Settings for Operating TELES.iTA/2TR Box
The TELES.iTA/2TR Box is set via a DTMF/“touch-tone” telephone (DTMF = Dual Tone
Multi Frequency) attached to any port of the box. The telephone should also have a
key
(tone) and a # key (pound/flash). Please refer to documentation that came with your telephone
to determine if your telephone is set to touch-tone dialing. If it isn’t, you should be able to
switch it from dial pulsing to touch-tone dialing.
All settings are made by entering a command sequence beginning with the
key followed by
a command number. Depending on the function desired, you then again enter the
key fol-
lowed by one or more numbers. Each number entered must be preceded by the
key. The
#
key finishes the command sequence.
command no.
number 1
number 2
number 3
#
If a setting was carried out successfully, you will hear a long beep. If a setting was unsuc-
cessful, or if you made a mistake, you will hear a trill.
Besides using a telephone for configuration, you can also make settings using a user-friendly
Windows software. All you need is an ISDN board for your PC – e.g. a TELES.BRI board
with the TELES.OnlinePowerPack application suite. This board should be attached to the
same ISDN line as the TELES.iTA/2TR Box (see section 5.6, page 26).
To configure your TELES.iTA/2TR Box, you must first configure your PIN (Personal Identi-
fication Number).
3.2.1 Configuring the PIN
Several important settings for your TELES.iTA/2TR Box require you to enter a PIN (Personal
Identification Number). The PIN must be a 5-digit number; PIN 00000 is configured by de-
fault. You can only perform one setting using the default PIN and that is configuring the PIN
to another number.
NOTE: It is imperative that you remember your newly configured PIN. We recommend
writing it down and storing it in a safe place. Should you forget your PIN, you will
be unable to change any settings! In this case you have to send your
TELES.iTA/2TR Box back to TELES for maintenance!
To change your PIN, enter the following command sequence:
90 oldPINnewPIN newPIN#
Example: To change the PIN from the default setting (PIN=00000) to 01234:
90 0000001234 01234#