Operation Manual

Installing the TELES.iTA/2TR Box

3.1 Attaching TELES.iTA/2TR Box

3.1.1 Attaching Power Supply

First, attach the external power supply to your TELES.iTA/2TR Box by plugging the power

cable into the power jack. Plug the power supply into an electric power outlet.

The TELES.iTA/2TR Box then conducts a diagnostic self-test. During the test each LED will

light up and the red power LED will remain lit.

3.1.2 Attaching Analog Devices

Attach your terminal equipment to the TR ports located at the back of the TELES.iTA/2TR

Box.

In the table below you will find a list of possible connections.

Device Connector Type of Connection

Devices with RJ-11 plugs

(international standard)

Attach your devices directly to the TR ports.

(see figure on page 3)

Devices with other plugs

Purchase an adapter from your local dealer that converts your plug

to a RJ-11.

The figure on the right shows the RJ-11 plug. The letters A and B indicate

the pins that are used. Lift the receiver and check if the LED for that port

lights up. You can attach a maximum of three terminal devices to each

TR port.

3.1.3 Attaching to ISDN

Attach your TELES.iTA/2TR Box to the ISDN line (also known as the BRI or S/T interface)

using the RJ-45 cable provided. To activate the ISDN line, lift the receiver of a telephone at-

tached to the TELES.iTA/2TR Box. The appropriate green port LED should light up and a

dial tone should be heard. If not, there is a problem with the ISDN line or the ISDN cable is

possibly defective (see chapter 6.3).