User's Manual

STATEMENT FOR MODUAL APPROVAL
This product is sold to OEM integrators only. The manual for the OEM integrators must include some
instructions to be followed by the end users in the user manual. For example:
The OEM integrators must be instructed to ensure that the end user has no manual instructions to remove
or install the device.
The OEM integrators must be instructed about the end product labeling ("Contains TX FCC ID:
MFM-11-136")
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as the 2 conditions above are met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end product for any additional compliance requirements
required with this module installed (for example, digital device emissions, PC peripheral requirements,
etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer considered
valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator
will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such that
20 cm may be maintained between the antenna and users (for example, access points, routers, wireless
ADSL modems, and similar equipment). The final end product must be labeled in a visible area with the
following: "Contains TX FCC ID: MFM-11 -136".
Manual Information for End Users
Following RF exposure info shall be supplied in end-users manual depends on the application.
For mobile configuration RF Exposure Information:
IMPORTANT NOTE:
To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile
Configurations. The antennas used for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter
For Laptop Configuration RF Exposure information:
This device has been tested for compliance with FCC RF Exposure (SAR) limits in the typical laptop
computer configuration and this device can be used in desktop or laptop computers with side mounted
PCMCIA slots. This device cannot be used with handheld PDAs (personal digital assistants).
This device and its antenna must not be co-located or operated in conjunction with any other antenna or
transmitter.