User's Manual

Extended Range Amplified WLAN System Guide
Version 07/18/02
3 Configuring the Extended Range Amplified WLAN System
3.1 Setting the Cisco Aironet Channel Settings
The Teletronics Extended Range Amplified WLAN System is approved for operation on seven (7) US
and Canada 802.11b operating frequency channels. These seven channels are a subset of the 11
US/Canada standard IEEE 802.11 channels. The wireless LAN installer should refer to the Cisco Aironet
product equipment User Guide and Installation Manual for specific channel configuration and setting
procedures. Table 3-1 below outlines the authorized 802.11 channels available for use with the extended
range WLAN system.
NOTE: This equipment is not authorized and may not be operated on IEEE 802.11 channels 1, 2, 10, and
11 at output power levels above 100mW. If you wish to interoperate with IEEE 802.11 Wireless LAN
compatible equipment on these excluded channels, you should NOT use this amplified antenna system.
This extended range amplified antenna system is for use at power levels above the Cisco Aironet
equipment’s standard 100mW output; and therefore you must set the Cisco Aironet equipment to use only
one of the channels (A-G) shown below.
Table 3-1: Authorized Cisco Aironet Channel Settings
Channel Corresponding IEEE 802.11 Channel Channel Center Frequency
NOT USED 1 2412
NOT USED 2 2417
A 3 2422
B 4 2427
C 5 2432
D 6 2437
E 7 2442
F 8 2447
G 9 2452
NOT USED 10 2457
NOT USED 11 2462