Sell Sheet

Antenna mounting / Montaje de la antena

MIX LR

Tighten the nuts (Y) until the square

neck of the carriage bolts (AC, AD) sinks

into the aluminum and the bolt head

sits ush with the boom.

PH #2





(a1)

(a2)

(a3)

(b1)

(b2)

(b3)



PAGE 1
MIX LR Antenna mounting / Montaje de la antena 1 B2 B1 (b1) B3 Y (b2) Y (a2) (a1) Y (b3) (a3) A A AC AD  A  Tighten the nuts (Y) until the square neck of the carriage bolts (AC, AD) sinks into the aluminum and the bolt head sits flush with the boom.
PAGE 2
6 K J  AB F K 7 8 P  K 9 Z O E P AF E A 10 11 CLICK! D D 12 13 AF O C S C E CLICK! 14 S AG AG S P E X C S X
PAGE 3
15 16 AI AI U 17 AI AI U C M M AI AI AI U 18 U M PH #2 M 19 U PH #2 N W AI M V AA PH #1 V AA 21 20 N CLICK! AA V V AA 23 22 24 AI T AI Y V A V PH #2 C AD When assembling the Low VHF dipole make sure to use the split bracket (part “T”) on the bottom side where the flat phase lines (part “V”) attach to the dipole, and the long bracket (part “U”) on the top side of the dipole. Reversing the order will short circuit the dipole.
PAGE 4
25 G CLICK! 26 CLICK! G 27 28 29 9/32” (7mm) 1/8” (3mm) R 30 31 33 TOP of Antenna The longest boom is the TOP part of the antenna. Q 32 Once assembled, during final installation note that the longer boom is the top part of the antenna, as indicated in this picture. The tilt/elevation adjustment on the mounting clamps, shown in the diagram 28, allows for adjustment of the vertical angle of the antenna as needed for optimum reception.