User manual

26
High De nition TV Satellite Receiver
Unicable
Your facility has a Unicable system, where you can connect
up to 8 receivers in a single cable.
 In the “IF Channel” option, select one of the 8 IF channels
for your receiver.
 If the center frequency for the selected channel is not
correct, select another in the “Center Frequency” option.
 Select one of the two ports on the “DiSEqC port” option
and assign a satellite to this port on the “Satellite” option.
The level bars will tell you if you have the satellite signal
and what is the strength and quality for each TV channel.
 By pressing the yellow key is shown the LNB Setup
submenu, where you can modify the o set of the LNB
(+1 V).
 By pressing the blue key displays the submenu where
you can select Advanced Settings values “ Auto”,1, 2, 3, 4
and 5 for the “Repeat DiSEqC” option.
Automatic channel searching
Using this menu option, it automatically searches for all
available channels in the band.
Select “Automatic Channel Search” option and press OK.
 If your antenna con guration has a DiSEqC device, you
must indicate which satellite you want for searching
channels, then press OK.
If in your antenna con guration, you selected “None”,
the search begins immediately.
 The search may take a few moments. Please wait.
 To stop the search at any time, press EXIT.
 After the search, the screen will show the number of
channels found of both TV and Radio.
 Press OK to start watching the channels.