User manual

29
EN
11.7. Maintenance
This section describes the steps required to update the
software on your HD ZAS SAT or reset to factory defaults.
Update Software (OTA)
Option for updating the receiver software through the
antenna signal.
Only if an updated software version is available over the air.
Update Software (USB)
If you have an updated software version and wish to
update the ZAS HD SAT, proceed as follows:
 Copy the software in a empty memory stick (pen drive)
FAT 32 in the root directory.
 Connect the memory stick to the receiver (front USB
connector).
 Select “USB Software Update” option and press OK.
 The ZAS HD SAT will look for the update and proceed
with its installation.
 The update may take a few moments. Please wait.
- This operation involves losing all data and
con gurations on the receiver.
Factory Settings
This menu allows you to delete all channels and return the
ZAS HD SAT to the initial state (factory default).
 Select the “Factory Settings” option and press OK.
 It then shows a warning message informing of the
consequences of carrying out this option. If you really
want to return the receiver to factory settings select
“YES” with the keys
or and press OK to con rm.
After reset, the receiver displays the Welcome window.
 To exit the menu without changing anything press EXIT
or select “NO” and press OK.
- This operation involves losing all data and
con gurations on the receiver.
- This does not a ect the recordings stored.