User Manual

BTR-30N, TR-30N, TR-32N Introduction 19
1. MENU and SET buttons - Used to select menus and set
options on the LCD.
2. LCD (Liquid Crystal Display)
3. UP and DOWN buttons - Used to select beltpack options
on the LCD.
4. Programming Connector - Used to update software in
unit.
5. Auxiliary Input Audio Jack - 1/85” (3.5mm) mono input
jack. Local only to beltpack.
6. Headset Connector - Male XLR connector or female
XLR. A dynamic or electret headset microphone is
automatically detected by the beltpack and a bias voltage
supplied, if needed. 4-pin RTS units are monaural. 5-pin
RTS units have a software setup to select if XLR pin 3 or 5
is the channel 2 output and if pin 3 is ground.
7. Battery Latch - Press down to release the battery pack.
While the latch is held down, slide the battery pack about 1/
8 inch back, toward the latch, until it stops, then lift it out.
8. Receive Antenna - Screw type 1/4-wave replaceable
antenna. The color dot on the screw end of the antenna must
match color dot on the antenna receptacle.
9. Transmit Antenna - Screw type rubber duck replaceable
antenna. The color bands near the screw end of the antenna
must match color dot on the antenna receptacle.
IMPORTANT: Microphone gain and transmit mode is
set via software menus.
FIGURE 8. TR-32N Rear Panel/ Connector/Antennas
FIGURE 9. Handset Jack Wiring