User Manual

BTR-30N, TR-30N, TR-32N Operation 39
Lockout
Lockout is us
ed to keep a user from changing any options at the
base station, except local headset microphone gain and volume.
To enable Lockout,
do the following:
> Press and hold UP+DOWN for two (2) seconds to lock
or unlock the base station.
A padlock appears on the status screen if the base is
locked out.
FIGURE 53. Status Screen with Lockout Active
Copy
Copy all
ows the user to select a factory-defined group and copy
it to a user-programmed group. This allows a user to edit the
group if desired.
FIGURE 54. Copy Screen
To use Copy, do the following:
> Press and hold the SET+DOWN buttons for 2 seconds
in the group/channel select screen (see Figure 54).
1st Use Defaults
1st Use Defaults
is used to set the base station to Group 01A,
channels 1, 2, 3, 4, and RETAIN any user-defined groups in
memory. It sets the unit to factory-defined parameters.
To set th
e base station to 1st Use Defaults, do the following:
1. Press and hold the MENU button while turning on the base
station.
2. When Factory Setup displays on the screen, release
MENU.
Factory Default
Factory Default is u
sed to set the base station to Group 01A,
channels 1, 2, 3, 4, and ERASES any user-defined groups in
memory. it sets the unit to factory-defined parameters.
To set the ba
se station to Factory Default, do the following:
> Press and hold MENU + SET + UP+ DOWN for two
(2) seconds. 
The screen in Figure 55 displays before the unit
reboots.
FIGURE 55. FACTORY SETUP Display