User Manual

BTR-30N, TR-30N, TR-32N Operation 37
2-Wire Intercom
The screens below show the pro
gression of setting 2-wire
parameters.
FIGURE 49. 2-Wire Intercoms
To adjust the 2-wire intercom settings, do the following:
1. From the status screen, press the MENU button.
2. Using the UP/DOWN arrow buttons, select Intercom
Settings.
3. Press SET.
4. Using the UP /DOWN arrow buttons, select 2-W.
5. Press SET.
The 2-wire intercom type flashes.
6. Using the UP/DOWN arrow buttons, set the intercom type.
7. When finished, press SET.
The intercom channel flashes.
NOTE: If of
f is selected, the 2-W/4-W menu options
appear.
8. Using the UP/DOWN arrow buttons, select the intercom
setup–intercom 1, intercom 2, or both.
9. Press SET.
The intercom input level flashes.
10. Using the UP/DOWN arrow buttons, select the input level.
11. When finished, press SET.
12. Proceed through the intercom settings.
Once finished, the screen displa
y returns to the 2-W/4-W
selection menu.
13. Press MENU twice to go back to the status screen.
NOTE: The base defau
lts back to the status screen if no
action is taken after five (5) minutes.
4-Wire Intercom
The screens below show the progressi
on of setting 4-wire
parameters.
FIGURE 50. 4-Wire Intercoms
To adjust the 4-wire intercom settings, do the following:
1. From the status screen, press the MENU button.
2. Using the UP/DOWN arrow buttons, select Intercom
Settings.
3. Press SET.
4. Using the UP /DOWN arrow buttons, select 4-W.
5. Press SET.
The intercom one 4-wire on/off selection flashes.
6. Using the UP/DOWN arrow buttons, select on or off.
7. When finished, press SET.
The intercom input level flashes.
NOTE: If of
f is selected, the screen skips to the intercom
two screen.
8. Using the UP/DOWN arrow buttons, select the intercom
setup–intercom 1, intercom 2, or both.
9. Press SET.
The intercom input level flashes.
10. Using the UP/DOWN arrow buttons, select the input level.
11. When finished, press SET.
12. Proceed through the intercom output settings in a similar
manner.
Once finished, the intercom two 4-wire on/off selection
fl
ashes.
13. Repeat steps 6-12 for intercom two.
Once finished, the screen displa
y returns to the 2-W/4-W
selection menu.
14. Press MENU twice to return to the status screen.
NOTE: Th
e base defaults back to the status screen if no
action is taken after five (5) minutes.