User Manual

FIGURE 20. Loop-through of two base stations connected with
Telex/Audiocom or Clear-Com Intercoms
FIGURE 21. Loop-through of two base stations connected with
RTS Intercoms
BTR-30N, TR-30N, TR-32N Operation 27
If multiple base stations are connected via 2 -wire intercom and
no 2-wire power supply is involved to terminate the 
2-wire, then termination plugs for the type of 2-wire system
used must be at one end of each intercom line.
Since RTS-TW carries both channels of audio on one (1) cable,
the four (4) intercom XLR connectors are connected in
parallel when RTS is selected. Thus any one (1) of the four (4)
intercom XLRs may be used for RTS input. Looping through of
the audio, shown in Figure 21, may also be accomplished via
any of the rear panel XLRs when in FTS mode. For a
description of how to set up the 2-wire ports, refer to Intercom
Settings in this section. The 2-wire intercom may be used at the
same time as the 4-wire intercom.