User Manual

36 Operation BTR-30N, TR-30N, TR-32N
To enable or disable the antenna power, do the following:
1. From the status screen, press MENU.
2. Using the UP/DOWN arrow buttons, select Base Main.
3. Press SET.
4. Using the UP/DOWN arrow buttons, select MORE... .
5. Press the DOWN arrow button.
The stage announce level starts flashing.
6. Press SET until Antenna Power flashes.
7. Using the UP/DOWN arrows, adjust the setting.
8. When finished, press SET.
9. Step through the other settings in the screen by pressing
SET.
After the last option on the screen, the base main selection
menu
appears.
10. Press MENU twice to go back to the status screen.
NOTE: The base defau
lts back to the status screen if no
action is taken after five (5) minutes.
CAN Bus Number
The C
AN Bus Number for a base station must be set only in
multiple base station configuration and only if the operator
wishes to have the following features shared among multiple
base stations:
• First-On-Latch – Out of receiver channels (Push to transmit)
• Automatic beltpack TX power control
• Automatic beltpack user ID assignment
• Beltpack TX and Talk shutdown via the base front panel
FIGURE 48. Base Number
Table 1 lists valid base number settings. Please see “Connection
of Multiple Base Stations with the Link Cables” on page 40.
To set the CAN bus number, do the following:
1. From the status screen press MENU.
2. Using the UP/DOWN arrow buttons select More...
3. Press the DOWN arrow button.
4. Press SET until the Base Number option flashes.
5. Using the UP/DOWN arrow buttons, set the number.
6. When finished, press SET.
7. Step through the other settings in the screen by pressing
SET.
After the last option on the screen, the base main selection
menu
appears.
8. Press MENU twice to go back to the status screen.
NOTE: Th
e base defaults back to the status screen if no
action is taken after five (5) minutes.
Intercom Settings
There are multiple parameters to set in the Intercom Setting
m
enu:
• 2-wire intercom type: Telex, RTS, Clear-Com, Off
• Only intercom 1 active, only intercom 2 active, both
• 2-wire intercom input/output levels
• 4-wire intercom on/off
• 4-wire intercom input/output levels
TABLE 1. Valid Base Number Settings
Base Number Function
01 Master
02 Servant
03 Servant
04 Servant
05 Servant
06 Servant
07 Servant
08 Servant
09 Unassigned (Default)