Hybrid DVR www.telexper.
1 nHybrid DVR Quick Installation Guide Introduction: nHybrid-16 / 32 / 48 4HDD Hybrid DVR Front View 16ch Hybrid DVR Rear View 32ch /48ch Hybrid DVR Rear View 8HDD Hybrid DVR Front View
2 Installation Diagram Connect the nHUB-4P by Power Cord using the CAT-6 RJ-45 cable to nHybrid Note: For dual monitor function (Live view + E-Map), please have 2 monitors connected to video output connectors on the back of nHybrid before staring the system.
3 Alarm In Cable
4 System Setup Flow Chart Take out nHybrid from the carton box (Important: Please ensure power-in switch on the back of nHybrid is the local voltage) Install HDD to caddy case (Important: 3.5” SATA II, III HDD is strongly recommended.
5 CMS Setup Set up Recording Schedule 1. On the Main screen, enter Setup page. 2. On the Setup page, enter Recording Schedule. 3. Hard Drive Selection: Select the Hard Drive you want to save for recording video/audio files. CMS will display the Estimated Total Hard Drive Storage automatically. 4. Setup Storage Space: At least 1GB shall be reserved for REC. 5. REC Speed Setting: Recording speed: 1~30 fps for the cameras 6.
6 How to Set up Static IP 1. On the Main screen, enter Setup page. 2. On the Setup page, enter Advance. 3. Uncheck “If a DHCP server present in the network, change the network setting to dhcp mode (instead of static IP)” 4. Select Realtek Ethernet Card, and then insert information such as Static IP and Default Gateway. 5. Before returning to Live Mode, the system will ask if you want to save the changes. Click Yes to complete setup.
7 When the Network Environment is managed by Router, how to Set up Port Forwarding 1. Please log in to your router 2. Enter the Virtual Server, set port “80” and “6741” for nHybrid. For example, if the nHybrid’s IP is 192.168.0.161, please set assign port “80” and “6741” for IP 192.168.0.161 3. After finishing set up, please save and log out the router.
