IP Bullet Camera www.telexper.
1 IP Camera Introduction Product Front View Product Rear View
2 Notice: * You can provide power to nCam Series cameras via Telexper PoE Gigabit Hub or you can connect DC12V In (pin-3) and GND (pin-4) for power supply (refer to above pictures). * Please use the CAT-6/CAT-5e RJ-45 cable to connect each Telexper camera. * The effective distance between the PoE Hub and IP camera is up to 100 meter.
3 Focal adjustment for manual vari-focal cameras: * Bullet Camera: (1) Remove the lens cover. (2) Loosen the two knobs on the lens to adjust focus. Tighten the knobs after adjustment.
