User's Guide
Table Of Contents
Wearable EVK User Guide
AN-21011301-E1
25
Ver.1.0.0
2. Jumper Connection Guide
There are 3 parts of EVK that use jumper, namely power supply, LED, RF PA.
2.1 Power Supply
There are four methods supported to supply power for the EVK.
• Via Telink Burning Board
• Via TLSR9 DEV KEY
• Via usb
• Via li battery
2.1.1 Via Telink Burning Board Power Supply
TLSR9518A power supply:
1. 3V3/SWS/GND of J75 corresponds to Burning Board 3V3/SWM/GND;
2. J74 short connection;
3. J19 short connection;
Simultaneously supply power to peripheral modules (3V3):
4. Connect 5V of J75 to Burning Board 5V;
5. J65 short connection;
6. Short connect the "BAT_LDO_3V3" of J5;
7. According to the silk screen on the back of J5, short connect correspondingly to supply power to the
peripheral module;